Table of Contents
Advertisement
next fixture. Note that it does not matter which network socket on the data
terminal is used.
B
C
12 Connect the transformer on the base to power at the terminal (C). See
"Connecting transformers to a power supply" on page 11 of this user
manual. Anchor the power cable using the clamp (B).
13 If the power and data cables are to pass out
through the side of the base cover then
remove the three rubber grommets that sit in
the base cover holes, make a cut in each of
them, place them over their respective cables,
and then push the grommets back into place
on the base cover.
14 Place the base cover over the base and screw
it into position using a 2.5 mm Allen wrench.
15 Rotate the mounting bracket and tilt the sphere to the correct position and
lock them into position using a 2.5 millimeter Allen wrench.
16 Apply power.
30
A
A
Installing an Alien 05 Stem Mount
Advertisement
Table of Contents
