Physical Installation; Location And Orientation; Mounting Fasteners - Martin Exterior 200 LED User Manual

Table of Contents

Advertisement

Physical installation

Warning! Read "Safety Information" on page 3 before installing the Exterior 200 LED.
Warning! The safety and suitability of lifting equipment, installation location, anchoring method,
mounting hardware and electrical installation is the responsibility of the installer. All local safety
regulations and legal requirements must be observed when installing and connecting the Exterior
200 LED. Installation must be carried out by qualified professionals only.
Contact your Martin Architectural™ supplier for assistance if you have any questions about how to
install this product safely.

Location and orientation

Warning! The Exterior 200 LED mounting yoke base must be securely anchored to a suitable flat
surface. Ensure that the supporting structure can bear the weight of all installed devices plus an
adequate safety margin.
Warning! If no diffuser filter is installed, make sure that it is impossible for LEDs to be viewed from a
distance of less than 2.2 meters (7 feet 3 inches).
If the diffuser front is installed, there is no eye hazard at any distance.
important! Make sure that there will be at least 0.1 m (4 in.) of free space and unrestricted airflow
around the fixture.
Allow for service access to the front and rear of the fixture.
The Exterior 200 LED can be installed outdoors. It has an IP rating of 65 and is designed to withstand rain
and other low-pressure water projections but:
• Do not expose it to high-pressure water jets from any direction
• Do not immerse it in water (or any other fluid)
• Do not install it in a location where flooding may occur.
Ensure sufficient drainage to cope with the heaviest rainfall. Make sure that water can drain away from the
installation area at least as fast as it can enter it.
The Exterior 200 LED requires free and unobstructed airflow around it to ensure adequate cooling:
• Do not bury the fixture or locate it in an unventilated space
• Allow 0.1 m (4 in.) free space around the fixture
Install the fixture at least 0.5 m (20 in.)away from any combustible materials (wood, paper, etc.) and well
away from any flammable materials.
The aluminum housing reaches temperatures up to 90° C (194° F). Restrict public access or locate the
fixture so that it cannot accidentally be touched.

Mounting fasteners

Warning! All fasteners used to mount the Exterior 200 LED must be corrosion-resistant and strong
enough to mount the fixture safely. The washers supplied with the fixture must be installed directly
under the fasteners' heads when anchoring the yoke base to the installation surface.
The mounting yoke base must be safely anchored to a horizontal surface. The number and type of fasteners
used will depend on the installation, but use at least three high-strength corrosion-resistant fasteners
(recommended minimum properties: stainless steel A4-70 grade according to ISO 3506 or steel grade 8.8
according to ISO 898-1). All nuts used must be self-locking. Washers must be installed between the head of
each fastener and the yoke base.
The yoke allows the fixture to be manually panned (i.e. rotated horizontally) and tilted for beam aiming
adjustment.
See Figure 1. To mount the fixture, use a 12 mm (1/2 inch) thread diameter bolt in the center hole A. Then
either use two bolts with 12 mm (1/2 inch) shaft diameter passing through holes B or use two bolts with 8
8
Exterior 200 LED user manual

Advertisement

Table of Contents
loading

Table of Contents