Table of Contents
Advertisement
Assembly and mounting
Assembling the panel and frame
To assemble the EvenLED panel and frame:
1. See Figure 1. Slide the panel mounts (11) into the panel mounting slits (8).
2. Retract the panel locks (12) by pushing them towards the centre of the panel.
3. Align the panel with the frame and release the panel locks (12) to lock the panel into the frame.
Mounting the EvenLED
One frame mounting bar and two rigging clamps approved for the total weight to be suspended are required
for each suspended vertical column of EvenLED panels.
To mount the EvenLED system:
1. Check that the pipe or truss onto which you are mounting the EvenLED system is horizontal.
2. See Figure 2. Loosen the clamp position locking rings (3) and slide the clamps (1) as wide apart as
possible but making sure they will still match up with the supporting truss or other structure.
3. Lock the clamp position locking rings (3) to secure the clamps in position.
4. Adjust the height of the frame mounting bar so that it can move freely by turning the height adjustment
bolt (2) counter-clockwise to lower the frame mounting bar, clockwise to raise it.
5. Loosen the frame mount locking knobs (4) and slide them towards centre of the frame mounting bar (6)
to open the locks in the frame mount holes (5).
8
Figure 1: Panel mounts
EvenLED user manual
Figure 2: Mounting hardware
Panel locks
Advertisement
Table of Contents
