Prerequisites; Install The Network - Martin Alien 05 User Manual

Hide thumbs Also See for Alien 05:

Table of Contents

P r e r e q u i s i t e s

Before installing the Alien 05 Eyeball:

• Install a Cooper Lighting, Halo brand, recessed low-volt non-IC fixture

housing (item # H7LVT). Connect the transformer on the fixture housing to

power. See the instructions supplied with the Halo fixture housing and

"Connecting transformers to a power supply" on page 11 of this user

manual.

• Ensure that you have a CAT5 network cable (category 5 UTP patch cable, 4

pairs, 24 AWG) that is not longer than 10 metres (33 feet), and that can be

run from the fixture housing to the 05 Driver unit.

• If you are daisy-chaining another Alien 05 then you need an additional CAT5

network cable, that is not longer than 10 metres (33 feet), to connect the

fixture housing to the next one.

Install the ne twork

A network cable junction box and steel mounting strap are supplied with the

Alien 05 Eyeball. These are installed on the recessed low-volt fixture

housing in the following way:

1 Thread the steel strap through the slots on the junction box.

2 Wrap the steel strap around the recessed fixture housing and through its

buckle. Tighten the buckle locking screw.

Installing an Alien 05 Eyeball

Table of Contents