Table of Contents
Advertisement
• Not more than 40 cable metres away from the 05 Driver/05 Repeater.
Warning
The Alien 05 Recessed is designed to be installed in a wall or
ceiling panel that is less than 20 mm (0.8 in) thick.
The standard Alien 05 can be modified for installation in a wall
or ceiling panel that is 20-30 mm (1.2 inches) in thickness. To
perform this modification order three Hexagon Socket Head Cab
Screws (M4x60) from your Martin dealer (P/N 08071205) and
change these with the three screws supplied with the product.
The product is not designed for installation in other
environments.
Ensure that Alien 05 Recessed models are installed with at least 50 mm (2
in) of clear space around the air vent at the rear of the fixture (total space
required including the depth of the fixture is 168 mm (6.6 in)).
P r e r e q u i s i t e s
Before installing the Alien 05 Recessed:
• Ensure that you have a 12 V AC halogen lamp transformer (not supplied).
Each Alien 05 draws 50 watts of power at 4.2 amps from an electronic
transformer that supplies 12 volt AC at 50 or 60 hertz. If you are installing
multiple Alien 05s you can use one or more transformers, specified to the
number of Alien 05s power is being supplied to, but note that the cable
length between transformers and the Alien 05 luminaires that they supply
power to must not be more than 45 cm (17.7 inches).
• Ensure that you have a CAT5 network cable (category 5 UTP patch cable, 4
pairs, 24 AWG) that is not longer than 10 metres (33 feet), and that can be
run from the Alien 05 to the 05 Driver unit.
• If you are daisy-chaining another Alien 05 then you need an additional CAT5
network cable, that is not longer than 10 metres (33 feet), to connect this
luminaire to the next one.
14
Installing an Alien 05 Recessed
Advertisement
Table of Contents
