Others; Troubleshooting - FUNAI BH2-M200 Owner's Manual

Others

Troubleshooting

Before requesting service for this unit, check the table below for a possible cause of the problem you are experiencing. Some
simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation.
Symptom
The power does not turn on.
The unit turns on automatically without
any operation.
The unit does not function.
No picture, sound or menu appears on
the screen.
"Clock" setting and "Installation" setting
cannot be performed.
The unit does not operate properly.
The clock display does not appear on
the front panel display.
When you forget the password for
parental lock.
No image from HDMI connection.
TV channels cannot be changed.
Some settings are lost even though you
followed the procedure correctly.
Only specific channels do not appear.
Though auto tuning was completed,
you cannot watch the DVB channels.
The TV channel which you were able to
watch before has disappeared and "No
signal" is displayed.
72
EN
• Check that the AC power cord is connected securely.
• Batteries of the remote control are weak.
• The unit turns on automatically 2 seconds before the timer recording.
• " " or error message appears if the operation is prohibited.
• Batteries of the remote control are weak or exhausted.
• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Check if a correct external input channel is selected on your TV. (See page 18.)
• Check if you have completed "Auto Tuning". (See page 58.)
• If a recording is in progress, these operations cannot be performed.
• Moisture has condensed inside the unit. Remove the disc and leave the unit
turned on for about 2 hours until the moisture evaporates. (See page 3.)
• Check that the AC power cord is connected securely.
• (In case of power failure) Check the breaker and "Clock" setting.
• Enter 4737 to cancel the current password, then create new one.
• Check the HDMI connection. (Check the status of the HDMI related indications.)
• Check whether the connected monitor device or other device supports HDCP.
(This unit will not output video signals unless the other device supports HDCP.)
• Check the setting of HDMI.
• Check whether the output format of this unit (HDMI FORMAT) matches the
supported input format of other connected device.
• If the unit is connected to the unauthorised display device with an HDMI cable,
the audio and video signals may not be output when playing back a commercial
BD-video or DVD-video.
• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try "Auto Tuning". (See page 58.)
• If you unplug the AC mains cable while the warning message, "Wait for a
moment...", is displayed, some settings may be lost. Do not unplug the AC
mains cable while the message is displayed. (It will take about 1 minute.)
• The channels may be set to be skipped. (See page 24.)
• Check whether an antenna cable is connected correctly and try tuning again.
• If you move to a different area, you need to perform auto tuning again.
Remedy