FUNAI BH2-M200 Owner's Manual page 64

Category Menus / Options
Settings Recording
Clock
64
EN
Bilingual Main
Recording Audio
Sub
Video
DVD-RW DVD-RW DVD-RW DVD-R DVD-R DVD-R
DVD+RW DVD+RW DVD+RW DVD+R DVD+R DVD+R
External Input Stereo
Audio
Bilingual
HDD HDD HDD BD-RE BD-RE BD-RE
BD-R BD-R BD-R DVD+RW DVD+RW DVD+RW
DVD+R DVD+R DVD+R
Video Colour Auto
System
PAL
SECAM
Clock Setting
- - / - - / - - - -
Auto Clock Setting On
Off
Descriptions
Selects either "Main" or "Sub" when dubbing a title
with bilingual audio to...
- a video mode or +VR mode DVD.
- a VR mode DVD when "Recording Audio Select
(XP)" is set to "PCM".
• When recording to HDD or Blu-ray Disc™, both
"Main" and "Sub" will be recorded regardless of
your setting here. And you can choose the
desired audio format as you playback later.
When the external input audio is a bilingual
broadcast, you can choose "Stereo" or "Bilingual"
as the recording audio.
• This setting is only for recording external input
("AV2").
• See also "Bilingual Recording Audio" above.
Lets you select the appropriate colour system to
match your TV.
"Auto":
The video colour system will be set automatically
according to the recording material.
"PAL":
The video colour system will be set to PAL.
"SECAM":
The video colour system will be set to SECAM.
• During recording, when a signal other than PAL
or SECAM is detected, an error message
appears on the screen and recording will be
paused. Recording will be resumed when a PAL
or SECAM signal is detected.
• Regardless of the setting here, recording colour
system is fixed to PAL.
• When PAL is selected, but the input signal is
SECAM or vice versa, the colour will not be
recorded correctly.
Press [ENTER\OK] so that the entry fields will be
available. Enter the date (day / month / year) and
Clock Setting
time using [K \ L] or [the Number buttons], then
( - - - )
press [ENTER\OK].
- - : - -
• Use [s \ B] to go back and forth among the
fields.
• Your clock setting will be lost if either there is a
power failure or the unit is unplugged for more
than 30 seconds.
• If "Auto Clock Setting" is set to "On" you cannot
select "Clock Setting".
Lets the unit adjust the clock automatically by
referring to the DVB time signal.
• Make sure "Initial Setting" (page 20) or "Auto
Tuning" (page 58) has been performed.
• The unit adjusts the clock at 1:00 a.m. only
under the condition when the unit is in the
standby mode. Adjusting takes about a few
minutes.