FUNAI BH2-M200 Owner's Manual page 21

5
Select the maturity level for DVB programmes,
then press [ENTER\OK].
• The programmes not recommended for the younger age
group than the age you set here will be blocked.
Initial Setting
Set Maturity Lock for Parental control.
-10
-12
-16
-18
6
Create a pincode which will be required to
change the "Channel Lock" or "Maturity Lock"
settings. Enter the desired number using
[the Number buttons], then press [ENTER\OK].
Initial Setting
Please input new pincode.
The pincode is used at Maturity Lock
and Channel Lock.
Don't forget the pincode.
Press [OK] to activate pincode.
• "0000" and "4737" are not available.
• Press [CLEAR] to erase numbers entered incorrectly at
once.
• Press [s] to erase the numbers entered incorrectly one
by one.
7
With "Start" highlighted, press [ENTER\OK].
Initial Setting
Auto Tuning
Make sure the antenna is
connected to "ANTENNA IN" jack.
Auto tuning will scan Digital channels.
This may take a while to complete.
Start
The unit will start getting channels available in your area.
• If no channel has been memorised, confirmation message
will appear.
After finishing channel setting, "Clock Setting" will
appear.
Initial Setting
Clock Setting
-- / -- / ---- (---)
-- : --
Wait for a moment.
Initial Setting
Clock Setting
1 / 1 / 2011 (SAT)
0 : 00
Setting complete.
Press [OK].
• The current date and time will appear automatically.
• If the current date and time are correct, press
[ENTER\OK] to exit. If they are incorrect, refer to "Clock
Setting" on page 64.
To redo "Initial Setting":
[SETUP] A "Settings" A "Others" A "Initial Setting"
• When redoing "Initial Setting" from the setup menu, the
maturity level setting (step
6
) will be skipped.
Note
• These initial setting items can also be accessed from the
setup menu screen. Refer to "Function Setup" table on
pages 57-67 for the available items in the setup menu.
• After "Initial Setting", if you need to unplug the mains cable,
make sure to turn off the power first and leave it in standby
mode for at least 1 minute before attempting to unplug.
Otherwise, it may cause data loss.
5
) and the pincode setting (step
EN
21