Installing Batteries In The Remote Control; How To Insert Disc; Switching Hdd / Disc Mode - FUNAI BH2-M200 Owner's Manual

Installing Batteries in the Remote
Control
Install 2 R6 (1.5V) batteries (supplied) into the remote control,
carefully match with the polarity indicated inside the battery
compartment.
1 2
Caution
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc.) batteries.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the remote control will not be used for a
month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
About the Remote Control
• Make sure there is no obstacle between the remote control
and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
5 m (30°)
• The maximum operable range as follows:
Line of sight: approximately 7 m
Either side of centre: approximately 5 m within 30 degrees
• Remote control operation may become unreliable if the
remote control sensor of the unit is being exposed by the
strong sunlight or fluorescent light.
• Remote controls for different devices can interfere with each
other. Be careful when using remote controls for other
devices located close to the unit.
• Replace the batteries when the operating range of the
remote control reduces.
12
EN
3
7 m 5 m (30°)

How to Insert Disc

1
Press [STANDBY\ON Q] to turn on the unit.
2
Press [OPEN\CLOSE A] to open the disc tray.
3
Place the disc on the tray.
4
Press [OPEN\CLOSE A] to close the disc tray.
5
Make sure to select the correct mode (HDD or
DISC), before operation.

Switching HDD / DISC Mode

Because this unit is a combination of HDD and Blu-ray Disc™
recorder, you must select the component you want to operate
by pressing [HDD] or [DISC] before you begin to operate.
DISC indicator
HDD indicator
HDD button
DISC button
Label side up
Disc tray guide
Corresponding indicator lights up.