Connections; Connecting To A Tv (Basic Connection); Antenna Connection - FUNAI BH2-M200 Owner's Manual

Connections

Connecting to a TV (Basic
Connection)
1
Disconnect the power cords of the devices from
the mains plug.
2
By referring to the following sections, make the
necessary connections.
3
After making all the connections, plug in the
power cords of the devices to the mains plug,
and select the appropriate input channel on
your TV.

Antenna Connection

Cable
Signal
Antenna
or
RF cable
(not supplied)
1
Audio / Video Connection
Standard Quality
Using the AV1 (TV) scart socket, or AUDIO/VIDEO
OUT jacks
Audio/video cable
OR
(not supplied)
16
EN
To Aerial jack
2
RF cable (supplied)
Scart cable
(not supplied)
Note
• If your TV does not have a scart socket, use a scart/RCA
cable, or scart adaptor.
Scart/RCA cable
(not supplied)
• Connect this unit directly to the TV. If the AV cables are
connected to a VHS, pictures may be distorted due to the
copy protection system.
• Use a commercially available adaptor if the video input jacks
of your TVs or monitors are the BNC type.
High Quality
Using the HDMI OUT Jack
this unit
After making connection...
Refer to "HDMI Video Resolution" setting in the "Function
Setup" table on page 65, and select the desired resolution to
output.
Refer to "HDMI / COAXIAL Audio Output" table on page 17 to
see how the digital audio is output from the HDMI OUT /
COAXIAL (digital audio out) jack.
Note for HDMI Audio
• HDMI outputs the video / audio signals without converting to
analogue signals.
• No audio connection is required.
• Use an HDMI cable with the HDMI logo (a certified HDMI
cable) for connection.
Scart adaptor
(not supplied)
HDMI cable (not supplied)
To HDMI
input jack
HDMI IN
TV