Carburetor Removal; Auto Bystarter - KYMCO Agility City 125 Service Manual

Cortesia de / Courtesy of: www.batmotos.com
5
. FUEL SYSTEM

CARBURETOR REMOVAL

Remove the frame right side cover. ( 2-4)
Disconnect the auto bystarter wire
connector.
Remove the met-in box. ( 2-3)
Loosen the drain screw and drain the fuel
from the float chamber.
Disconnect the fuel tube and vacuum tube at
the carburetor.
Disconnect the TPS coupler and remove the
TPS unit
Loosen the throttle cable adjusting nut and
lock nut, and disconnect the throttle cable
from the carburetor.
Loosen the carburetor intake manifold band
and air cleaner connecting tube band screws
and then remove the carburetor.

AUTO BYSTARTER

OPERATION INSPECTION
Measure the resistance between the auto
bystarter wire terminals.
Resistance: 10 max. (10 minutes
minimum after stopping the engine)
If the reading is not within the limit, replace
the auto bystarter with a new one.
Recambios KYMCO en www.batmotos.com
AGILITY CITY 125
Auto Bystarter
Auto Bystarter Wire
Fuel Tube
TPS Unit
Air Cleaner Connecting
Tube Band
Throttle Cable
Adjusting Nut
Vacuum Tube Intake Manifold
Band
Lock Nut
5-4