KYMCO Agility City 125 Service Manual page 147

Cortesia de / Courtesy of: www.batmotos.com
13
. REAR WHEEL/REAR BRAKE/
REAR SUSPENSION
Apply a small amount of engine oil to the felt
seal and install it to the brake cam.
Install the brake arm.
Align the wide groove on the wear
indicator plate with the wide tooth of the
brake cam.
Install and tighten the brake arm bolt.
Align the scribed line on the brake arm
with the punch mark on the brake cam.
Install the brake arm return spring.
Install the brake arm pin.
Connect the brake cable and install the
adjusting nut.
Install the rear wheel. ( 13-2)
Adjust the rear brake lever free play.
( 3-8)
LEFT REAR SHOCK ABSORBER
REMOVAL
Remove the frame body cover. ( 2-3)
Remove the air cleaner case. ( 5-19)
Remove the rear shock absorber upper and
lower mount bolts.
Remove the rear shock absorber.
DISASSEMBLY
Install the rear shock absorber compressor as
the figure shown.
Install the rear shock absorber lower
joint into the rear shock absorber
compressor.
Compress the rear shock absorber spring.
Special
Cushion Assemble & Disassemble Tool
Recambios KYMCO en www.batmotos.com
AGILITY CITY 125
Return Spring
Brake Cable
Rear Shock Absorbers
Rear Shock Absorber Compressor
Loosen the lower joint lock nut.
Remove the lower joint.
Remove the lock nut, rubber and damper.
Cushion Assemble & Disassemble Too
Brake Arm
Brake Arm
Adjusting Nut
Upper Mount Bolts
Lower Mount Bolts
13-4