KYMCO Agility City 125 Service Manual page 63

Cortesia de / Courtesy of: www.batmotos.com
5
. FUEL SYSTEM
INSPECTION
Inspect the float valve and valve seat for
damage or clogging.
Inspect the float valve and valve seat
contact area for stepped wear or
contamination.
Worn or contaminated float valve and
valve seat must be replaced because it
will result in float level too high due to
incomplete airtightness.
ASSEMBLY
Install the slow jet, needle jet, needle jet
holder, main jet and pilot screw.
Return the pilot screw to the original
position as noted during removal.
Standard Opening:3
Install the float valve, float and float pin.
FLOAT LEVEL INSPECTION
Check the operation of the float valve
and float before this inspection.
Measure the float level by placing the
float level gauge on the float chamber
face parallel with the main jet.
Measure the float level.
Float Level: 17.0mm
This installation sequence is the reverse of
removal.
5-9
Recambios KYMCO en www.batmotos.com
/
1 turns
2
AGILITY CITY 125
Needle Jet Holder
Pilot Screw
Needle Jet
Float
Float Pin
Float Level Gauge
Valve Seat
Slow Jet
Main Jet
Float Valve