KYMCO Agility City 125 Service Manual page 130

Cortesia de / Courtesy of: www.batmotos.com
12
. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
HYDRAULIC BRAKE (FRONT BRAKE)
Brake Fluid Replacement/Air Bleeding
Check the brake fluid level on level ground.
When operating the brake lever, the
brake reservoir cap must be tightened
securely to avoid spill of brake fluid.
When servicing the brake system, use
shop towels to cover plastic parts and
coated surfaces to avoid damage
caused by spill of brake fluid.
Brake Fluid Bleeding
In order to avoid spill of brake fluid, connect
a transparent hose to the bleed valve.
Warning
Brake fluid spilled on brake pads or
brake disk will reduce the braking
effect. Clean the brake pads and brake
disk with a high quality brake degreaser.
Fully apply the brake lever and then loosen
the brake caliper bleed valve to drain the
brake fluid until there is no air bubbles in the
brake fluid. Then, tighten the bleed valve.
Repeat these steps until the brake system is
free of air.
Brake Fluid Refilling
Add DOT-4 brake fluid to the brake
reservoir.
When bleeding, be careful not to allow
air in the brake reservoir flowing into
the brake system.
When using a brake bleeder, follow
the manufacturer's instructions.
Never use dirty or unspecified brake
fluid or mix different brake fluids be-
cause it will damage the brake system.
Make sure to bleed air from the brake system.
Recambios KYMCO en www.batmotos.com
AGILITY CITY 125
Upper Limit
Lower Limit
Bleed Valve
Front Brake Caliper
12-8