Carburetor Removal; Auto Bystarter - KYMCO Agility 125 Service Manual

5
. FUEL SYSTEM

CARBURETOR REMOVAL

Remove the frame right side cover. ( 2-4)
Disconnect the auto bystarter wire
connector.
Remove the met-in box. ( 2-3)
Loosen the drain screw and drain the fuel
from the float chamber.
Disconnect the fuel tube and vacuum tube at
the carburetor.
Loosen the throttle cable adjusting nut and
lock nut, and disconnect the throttle cable
from the carburetor.
Loosen the carburetor intake manifold band
and air cleaner connecting tube band screws
and then remove the carburetor.

AUTO BYSTARTER

OPERATION INSPECTION
Measure the resistance between the auto
bystarter wire terminals.
Resistance: 10Ω max. (10 minutes
minimum after stopping the engine)
If the reading is not within the limit, replace
the auto bystarter with a new one.
Auto Bystarter Wire
Fuel Tube
Air Cleaner Connecting
Tube Band
Throttle Cable Adjusting Nut
AGILITY 125
Auto Bystarter
Vacuum Tube Intake Manifold
Band
Lock Nut
5-4