Section 10: T-54 Installation And Operation - Uponor Climate Control Zoning System Installation Manual

Section 10
Climate Co ˘ ntrol
T-54 Installation Guide
This quick-start guide provides instructions for installing
T-54 Thermostats (A3600054) for use with the Uponor
Climate Co ˘ ntrol™ Zoning System. Please refer to the
Climate Co ˘ ntrol Zoning System Installation Guide (which
comes with the base unit for A3601000 and A3601012)
for other information not pertaining specifically to the
T-54 Thermostat.
Note: The T-54 Thermostat Installation Guide is only
available in the Zoning System base unit packaging.
The following accessories are available for use with the
T-54 Thermostat:
• A3600010 Slab Sensor, 10K
• A3600254 Outdoor Sensor, 10K
• A3600154 Mounting Kit
Important: Do not use other 10K sensors with the
T-54 Thermostat, as other types of sensors will provide
inaccurate temperature information.
Uponor Climate Co ˘ ntrol™ Zoning System Installation Guide
Zoning
™
Step 1: Package Contents
Confirm the contents of the package, which include:
• T-54 Thermostat
• Two AAA batteries
• Hardware pack, anchors
and label
Note: If any contents
are missing, contact your
Uponor representative for
assistance.
Step 2: Battery Installation
Open the back of the T-54, insert the batteries and attach
the appropriate sensor (if used).
Step 3: Set the Dip Switches
Refer to the Dip Switch Chart on the next page to
properly set the dip switches for the external sensor. To
activate the feature, move the dip switch to the ON
position.
37