Applications - Carrier 58MXA Installation, Start-Up, And Operating Instructions Manual

r--- BLOWER SHELF _ FURNACE
/
X DOOR
/_ CONDENSATE
J f r-- CONDENSATE
\ /
TRAP
/ /
TRAP (INSIDE)
X
/
FURNACE
X ] s'w
FIELD 2 '4 1 '2
/ _ \ DRAIN
X---ALTERNATE DRAIN \ CONN
TUBE LOCATION
\
CONDENSATE TRAP _ SIDE VIEW FRONT VIEW
DRAIN TUBE LOCATION
DOWNFLOW AND ALTERNATE
UPFLOW APPLICATIONS EXTERNAL UPFLOW APPLICATIONS
FURNACE
OOR ! FURNACE
IDE
DRAIN
CONN
END VIEW FRONT VIEW
HORIZONTAL
APPLICATIONS
7
(OPTIONAL) /
._111/2 /
GUIDES
(WHEN USED)
FRONT VIEW
71/8
7/8 Z
:
SIDE VIEW
Fig. 5--Condensate Trap
/40D
COLLECTOR BOX TO
TRAP RELIEF PORT
%OD
INDUCER HOUSING
DRAIN CONNECTION
/80D
COLLECTOR BOX
DRAIN CONNECTION
SCREW HOLE FOR
UPFLOW OR DOWN-
FLOW APPLICATIONS
(OPTIONAL)
V2-1N PVC OR CPVC
CONDENSATE TRAP TUBING (ALTERNATE UPFLOW
ORIENTATION)
NOTE: See Fig 7 or robe routing label on nmin I_urnace door to
confim_ location of these tubes
1, (ollector Box Drain Tube
(onnect collector box &ain robe (blue label) to condensate
trap,
NOTE: On 17=1/2 in wide k'urnaces ONLY, cut tube between
corrugated sections to prevent kinks from occurring,
2, Inducer Housing Drain Tube
a, Remove and discard LOWER (molded) inducer housing
drain tube which was previously connected to condensate
trap,
b, Use inducer housing &ain extension tube (violet label and
factory-supplied in loose parts bag) to connect LOWER
inducer housing drain connection to the condensate trap,
c Detem_ine appropriate length, cut, and connect robe,
d, (lamp robe to prevent any condensate leakage,
3, Relief Port Tube
a (onnect relief port tube (green label) to condensate trap,
b, Extend this robe (if required) by splicing to snmll diameter
robe (factory=supplied in loose parts bag),
c Detem_ine appropriate length, cut, and connect robe,
A93026
CONDENSATE TRAP FIELD DRAIN ATTACHMENT
Refer to Condensate Drain section for recommendations and
procedures,
PRESSURE SWITCH TL BING
The LOWER collector box pressure robe (pink label) is facto U
connected to the pressure switch and should not require any
modification,
NOTE: See Fig. 6 or 7 or robe routing label on main Nrnace door
to check for proper connections,
UPPER (OLLECTOR BOX AND INDU(ER HOUSING
(L NUSED) DRAIN CONNECTIONS
Erpper Collector Box Drain Connection
Attached to the UPPER collector box drain connection is a
factow-installed corrugated, plugged tube (blue and white striped
1abel), This tube is plugged to prevent condensate teakage in this
application Ensure this robe is plugged,
NOTE: See Fig 6 or 7 or robe routing label on nmin f_ulmce door
to check for proper connections
Upper Inducer Housing Drain Connection
Attached to the [?PPER (unused) inducer housing &ain connection
is a cap and clamp, This cap is used to prevent condensate leakage
in this application, Ensure this connection is capped,
NOTE: See Fig, 6 or 7 or robe routing label on nmin fi/rnace door
to check for proper connections,