Vent Extension Pipe - Carrier 58MXA Installation, Start-Up, And Operating Instructions Manual

HORIZONTAL TO ROOF
--,,I.-- 12"
MIN---,,-- I
I 4
VENT P,PE --
l_lt/'-- CO MBUSTION-AIR PIPE
HORIZONTALTO SIDEWALL
COMBUSTION-AIR PIPE --""_"I
MIN ,_m,,-
COMBUSTION-AIR PiPE
/-- VENT PiPE
VERTICAL TO ROOF VERTICAL TO SIDEWALL
NOTE: A 12 In. minimum offset pipe section is recommended with
short (5 to 8 ft) vent systems. This recommendation is to reduce
excessive condensate droplets from exiting the vent pipe
Fig. 34--Short Vent {5 to 8 Ft) System
A96230
TaNe 6--Approved Combustion-Air and Vent Pipe,Fitting and Cement Materials
ASTM SPECIFICATION
(MARKED ON MATER_AL)
D1527
D1785
D2235
D2241
D2488
D2488
D2564
D2661
D2885
MATERIAL PiPE FITTINGS
ABS Pipe --
PVC Pipe --
For ABS -- --
PVC Pipe --
PVC -- Fittings
ABS -- Fittings
For PVC -- --
ABS Pipe Fittings
PVC Pipe Fittings
SOLVENT CEMENT AND PRBMERS
Solvent
Cement
Sotvent
Cement
DESCRIPTBON
Schedule-40
Schedule-40
For ABS
SDR-21 & SDR-26
Schedule-40
Schedule-40
For PVC
DWV at Schedule-40 tPS sizes
DWV
F438
F441
F442
F493
F628
F856
F891
CPVC -- Fittings
CPVC Pipe --
CPVC Pipe --
For CPVC -- --
ABS Pipe --
For PVC -- --
PVC Pipe --
Solvent
Cement
Primer
Schedule-40
Schedule-40
SDR
For CPVC
Cellular Core DWV at Schedule-40 IPS sizes
For PVC
Ceitular Core Schedule-40 & DWV
3_ Working fiom ft_rnace to outside, cut pipe to required
length(s)_
4. Deburr inside and outside of pipe
5. (hamlet outside edge of pipe for better distribution of primer
and cement
6. (lean and d_ all sur_i_ces to be joined.
28
7. (beck &y fit of pipe and mark insertion depth on pipe
NOTE: It is recommended that all pipes be cut, prepared, and
preassembled be_bre pem_anently cementing any joint.
8. ARer pipes have been cut and preassembled, apply generous
layer of cement primer to pipe fitting socket and end of pipe
to insertion mark. Quickly apply approved cement to end of
pipe and fitting socket (over primer). Apply cement in a light,