Prime Condensate Trap With Water - Carrier 58MXA Installation, Start-Up, And Operating Instructions Manual

_/// _1t/_
COMBUSTION
J
J
AIR
A96129
Fig. 44_Raised SidewNl Termination When Wail
Penetration is 12 in. or Less Above Snow or Grade
(Dimension "A" is Touching or 2=in. Maximum
Separation}
/
J
OPEN STAND -'7
PIPE FOR /
A/C OR/
HUMIDIFIER d
DRAIN
TEE U_
A94054
Fig. 46--Example of Field Drain Attachment
CONDENSATE
COMBUSTION AIR
A96130
Fig. 45--Sidewall Termination of More than 12 in.
(Dimension "A" is Touching or 2-in. Maximum
Separation}
UNIT MAY NOT OPERATE
Failure to follow this caution may result in intermittent unit
operation
These furnaces are equipped with a manual reset limit switch
in burner box. This switch wil! open and shut offpower to gas
valve if an overheat condition (flame rollout) occurs in burner
enclosure. Correct inadequate combustion=air supply or ira=
proper venting condition and reset switch. DO NOT jumper
this switch_
Befbre operating fumacQ check flanre roll=out manual reset switch
for continuity_ If necessaD', press button to reset sx_itch
WIRE TIEq
HEAT
(3 WRAPS MINIMUM)
36
A93036
Fig. 47--Condensate Trap Heat Tape
Step 2--Prime Condensate Trap With Water
UNIT MAY NOT OPERATE
Failure to _bltow this caution may result in intem_ittent unit
operatiom
Condensate trap must be PRIMED or proper draining may not
occur The condensate trap has 2 internal chambers which can
ONLY be primed by pouring water into the inducer drain side
of condensate trap_
1_ Remove upper inducer housing &ain connection ca D (See
Fig. 48.)
Z (onnect fiel&supplied 1i2=in_ ID robe to upper inducer
housing &ain connection.