Carrier 58MXA Installation, Start-Up, And Operating Instructions Manual page 8

PLUG
COLLECTOR
DRAIN TUBE (BLUE
& WHITE STRIPED)
COLLECTOR
TUBE (PINK)
COLLECTOR BOX "-_
TUBE (GREEN)
INDUCER
(MOLDED) DRAIN
TUBE (BEHIND
COLLECTOR BOX
DRAIN TUBE)
DRAIN TUBE (BLUE)
FACTORY-SUPPLIED
DRAIN TUBE
COUPLING (LEFT
DRAIN OPTION)
PLUG
CAP
COLLECTOR BOX
DRAIN TUBE (BLUE
& WHITE STRIPED)
COLLECTOR BOX
TUBE (PINK)
COLLECTOR BOX --
TUBE (GREEN)
COLLECTOR BOX --
DRAIN TUBE (BLUE)
CONDENSATE _
TRAP EL
INDUCER J
HOUSING
DRAIN TUBE
(VIOLET)
©
O O
FIELD-INSTALLED
FACTORY-SUPPLIED
DRAIN TUBE
FIELD-INSTALLED
FACTORY-SUPPLIED
_i2-1N CPVC STREET
ELBOWS (2) FOR
LEFT DRAIN OPTION
FIELD-INSTALLED
FACTORY-SUPPLIED
DRAIN TUBE
COUPLING (RIGHT
DRAIN OPTION)
A94163
Fig. 6--Factory-Shipped Upflow Tube
Configuration (Shown w{th BNower Access Panel
Removed}
CONDENSATE TRAP FREEZE PROTECTION
Ref?r to Condensate Drain Protection section %r recommenda°
lions and procedures.
Step 3--Downfiow Applications
A downflow _/mace application is where :_trnace blower is located
above congbustion and controls section of fi_rnace, and conditioned
air is discharged downwards
( ONDENSATE TRAP LO(ATION
The condensate tlap mttst be removed from the factow-installed
blower shelf location and relocated in selected application location
as shown in Fig. 2, 8, or 9
To relocate condensate trap from the blower shelf to desired
location, perform the following:
1. Remove 3 robes connected to condensate trap
2. Remove tlap fiom blower shelf by gently pushing tabs inward
and rotating trap
3. Remove casing hole filler cap from casing hole. (See Fig. 2, 8,
or 9.)
4. [nstall casing hole filler cap into blower shelf hole where trap
was removed
-->
A94164
Fig. 7--ARernate Upflow Configuration and Trap
Location
CARBON MONOXIDE POISONING HAZARD
Failm'e to follow this warning could result in personal inju W
or death,
Casing hole filler cap must be installed in blower shelf hole
when condensate trap is relocated to prevent combustion
products being drawn in from appliances in the equipment
roonl.
5. [nstall condensate trap into desired casing hole by inserting
robe connection stubs through casing hole and rotating until
tabs snap into locking position,
CONDENSATE TRAP TUBING
NOTE: See Fig 8 or 9 or tube routing label on main f:umace door
to check for proper connections,
Relocate robes as described below,
1. Collector Box Drain Tube
a. Remove factory=installed plug from LOWER collector box
drain robe (blue and white striped label),
b. Install removed clamp and plug into UPPER collector box
&ain robe (blue label) which was connected to condensate
t_ap.
c (onnect LOWER collector box drain connection to con=
densate trap.
(i) (ondensate Trap Located on Left Side of (asing
(a) (onnect LOWER collector box &ain robe (blue
and white striped 1abel) to condensate trap. Tube
does not need to be cut.
(b) Clamp tube to prevent any condensate leakage.