ZPrinter
850 User Manual
®
6. Reach into the right end of the printer and wipe the 3 Piston Screws clean of old grease, dust, etc. If
reaching the left rear screw is too difficult, also remove the left side panel and reach in from there as
shown below.
7. Touch the grease gun to the Piston Screw and squeeze the trigger twice at the top of the Piston
Screw (under the Build Bed), and then squeeze the trigger once at the middle of the Piston Screw.
3dscentral.3dsystems.com
5/12/13
Number
Component
1
Electronics Box (E-Box)
2
Left Rear Piston Screw
3
Drive Pully
4
Drive Belt
52
Printer Maintenance
All Rights Reserved