ProJet
860Pro User Manual
®
Solution - Print Heads
Troubleshoot using
Section 7.3, 'Print Head Errors/ Weak
Solution - Motion Problems
•
Clean the Fast Axis Rails. See
•
Clean the Fast Axis Pulleys. See
•
Clean the Slow Axis Rails and Pulleys. See
7.12 Miscellaneous Problems
7.12.1 Vacuum Has Low/No Suction
Explanation: This is usually an indication that the Debris Separator needs to be emptied and cleaned.
Solution:
•
Remove the Debris Separator and empty the contents into a waste receptacle.
•
Check that its gasket is not damaged. Also check that all four magnets are in place on the back of the
Separator. These magnets hold the Separator against the panel.
•
When you replace the Debris Separator, ensure that it is flush against the panel.
•
Check the vacuum hose is not plugged with debris.
•
Check that the vacuum hose is not cut or torn.
If, after checking these items the problem persists, contact your Service Provider.
3dscentral.3dsystems.com
5/12/13
Parts'.
Section 3.4, 'Clean The Fast Axis Rails and
Section 6.6, 'Clean The Fast Axis
Section 6.7, 'Clean The Slow Axis Rails and
76
Troubleshooting the ProJet x60Pro
Carriage'.
Pulleys'.
All Rights Reserved
Pulleys'.