Table of Contents
Advertisement
ZPrinter
850 User Manual
®
11. Slide the Carriage back and forth to distribute the oil evenly over the Rails.
12. Reset the Maintenance Counter in 3D Print.
6.2 Piston Screw Lubrication - ProJet 660Pro
1. Remove the back cover panel of the printer.
2. Remove the right side panel.
3. On the LCD display, select
and lower the Build Bed platform as far as you can to expose the entire length of the piston screw.
4. Assemble the grease gun that is part of your Accessories Kit according to the instructions found in the
document 09576 Grease Gun Loading Instructions, which is supplied in the materials that were
shipped with the printer. You can also find these instructions on our Web site at:
3dscentral.3dsystems.com.
5. Look into the left end of the printer, in between the Waste Tray and the pocket for the Cleaning Solu-
tion Cartridge and locate the piston screw.
3dscentral.3dsystems.com
5/12/13
Number
Component
1
Oil Reservoir
2
Oil Reservoir Cap
BUILD CHAMBER > LOWER PLATFORM.
48
Printer Maintenance
Hold the Control Knob down
All Rights Reserved
Advertisement
Table of Contents
