ZPrinter
850 User Manual
®
8. Spread the grease up and down the Piston Screw to evenly distribute it over the entire length of the
screw.
9. Move the Build Bed up and down through its full range of travel a couple of times to finish lubricating
the screw. Use the LCD menu items
CHAMBER > LOWER PLATFORM
platform.
10. Wipe off any grease that may collect at the bottom of the screw with a paper towel.
Replace the side and back cover panels.
6.3 Piston Screw Lubrication - ProJet 860Pro
Frequency: When prompted to in 3D Print.
1. Remove the back cover panel of the printer.
2. Remove the right side panel.
3. On the LCD display, select
and lower the Build Bed platform as far as you can to expose the entire length of the piston screw.
4. Assemble the grease gun that is part of your Accessories Kit according to the instructions found in the
document 09576 Grease Gun Loading Instructions, which is supplied in the materials that were
shipped with the printer. You can also find these instructions on our Web site at:
3dscentral.3dsystems.com.
5. Look into the right side of the printer, next to the Waste Tray and in front of the blower motor and locate
the 3 piston screws.
3dscentral.3dsystems.com
5/12/13
BUILD CHAMBER > RAISE PLATFORM
. Don't forget to hold down the Control Knob to raise or lower the
BUILD CHAMBER > LOWER PLATFORM.
50
Printer Maintenance
and
BUILD
Hold the Control Knob down
All Rights Reserved