Table of Contents
Advertisement
®
ProJet
x60Pro Series User Guide
NOTE: Unused Core that is emptied or vacuumed from the Build Bed is recycled back into the
printer Feeder so it can be used for future builds.
2.10 Fine Cleaning
After the bulk of the Core is removed from the Build Bed, gently pick up the part and place it in the built-in
Post-Processing Unit (660Pro) or in the Core Recycling Station (CRS) where you can clean the part of any
remaining Core with the Air Wand.
2.10.1 Fine Cleaning Using the Post-Processing Unit (660Pro Only)
1. Open the printer top cover.
2. Ensure that the Fast Axis is pushed all the way back into its parked position.
3. Select
BUILD CHAMBER > RAISE PLATFORM
raise the platform closer to the top of the Build Bed.
4. Gently lift the part and place it in the Post-Processing Unit.
2.10.2 Fine Cleaning Using the Core Recycling Station
Transfer the part(s) to the Core Recycling Station following the steps below and perform the necessary fine
cleaning operations. Refer to the Core Recycling Station User Guide for complete details.
2.10.3 Moving Parts By Hand
1. Open the glass cover of the CRS.
2. Open the printer top cover and gently remove the part from the Build Bed.
3. For easier part removal, select
down the Control Knob to raise the platform to the top of the Build Bed.
4. Move the part to the CRS. Close the Station cover.
5. Close the printer top cover.
2.10.4 Moving Parts Using the Part Cart
1. Open the glass cover of the Core Recycling Station.
3dscentral.3dsystems.com
5/12/13
on the LCD menu. Hold the Control Knob down to
then
BUILD CHAMBER
23
Setup And Print The Build
on the LCD menu. Hold
RAISE PLATFORM
All Rights Reserved
Advertisement
Table of Contents
