Reset Mode Procedures
DataTran Function Table
Function
Initialize EFT
Open Batch
Close Batch
Clear Current Batch
Change Batch Number
Issue Local Total
Issue Transaction
Issue Batch Status
Dial In Load
Dial Out Load
Tip Entry
Pin Pad Initialize
Close Batch with Debit
* Version 6.8 or later; earlier versions use Z mode.
Initialize EFT
Z-Mode: Enter 500, press SBTL
Select Initialize EFT to verify communications, software versions and installed networks.
List of Installed Networks
Status of Installed
Clear Curr Batch
S-Mode: Enter 503, press SBTL
The clear batch command erases all the current batch transactions from the DataTran memory even if
they have not been settled. A LOCAL TRANSACTION INQUIRY should be printed prior to clearing
the batch. This will ensure that the operator has the transaction detail to re-enter if required.
This operation should only be done under the direction of DATACAP.
182 • Integrated Payment Appendix
Procedure
Z-Mode: Enter 500, press SBTL
Z-Mode: Enter 501, press SBTL
Z-Mode: Enter 502, press SBTL
S-Mode: Enter 503, press SBTL*
Z-Mode: Enter 504, press SBTL
Z-Mode: Enter 505, press SBTL
Z-Mode: Enter 506, press SBTL
Z-Mode: Enter 507, press SBTL
Z-Mode: Enter 508, press SBTL
Z-Mode: Enter 509, press SBTL
Z-Mode: Enter 510, press SBTL
Z-Mode: Enter 511, press SBTL
Z-Mode: Enter 512, press SBTL
DATE 5/24/2004 THU
TIME 16:15
** LIST INSTALLED NETWORKS **
VS2 CHK GFT --- VER:4.00
ON ON ON OFF
CLERK1
000066 00000
ER-5215M Electronic Cash Register v2.23
Software Version