Function Key Programming; Program 70 - Function Key Options - Sam4s ER-5215M Operator's And Programming Manual

Function Key Programming

Three programs are used to program function keys:
In this chapter you will find:

Program 70 - Function Key Options

Use Program 70 to set options for function keys. Because of the differences inherent in function keys,
individual options will be different. See the specific instructions for each key in this chapter to find
the options for each key.
120 • P-Mode Programming
 Program 70 - is used to set individual options for each function key
 Program 80 - is used to program a 12-character alphanumeric descriptor. In the case of
the #/No Sale key, provision is made to program a separate descriptor for the # and No
Sale functions.
 Program 90 - is used to set a high amount limit (HALO). In the case of percentage keys
(%1-%5) the percentage rate or amount is programmed; In the case of currency
conversion keys, the conversion rate is programmed.
 General instructions for programs 70, 80 and 90.
 Specific Program 70 option programming instructions for each function key.
1. Turn the control lock to the P position.
2. To begin the program, enter 7 0, press the SBTL key.
7 0 SBTL
3. Enter the values for the option digit or digits. Depending on the function key you are
programming, you may enter up to six digits N1 through N6. Determine the values for
N1 through N6 by referring to the specific function key information that follows. (You
do not need to enter preceding zeros. For example, if the function key offers six digits,
N1 through N6 and you are only selecting a value for N6, just enter the value for N6.)
Press the function key you wish to program.
N1 N2 N3
4. To program additional function keys, repeat from step 3, or press the CASH key to
finalize the program.
CASH
FUNCTION
N4 N5 N6
KEY
ER-5215M Electronic Cash Register v2.23