Table of Contents
Advertisement
1.2.2 AC/Power Precautions
1.2.3 Lamp Precautions
J Series 2.0, 2.4, and 3.0kW Setup Guide
020-100751-03 Rev. 1 (02-2014)
Use only the AC power cord supplied. Do not attempt operation if the AC
supply and cord are not within the specified voltage and power range. See
the license label on the back of the projector or
voltage and power.
The projector is equipped with a 3-wire plug with a grounding pin. This is a
safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to have the outlet replaced. NEVER defeat the safety purpose of
the grounding-type plug.
Do not allow anything to rest on the power cord. Locate the power cord
where persons walking on it or objects rolling over it cannot damage the cord.
Never attempt to access the lamp while the lamp is ON. After turning the
lamp OFF, it is crucial that you wait at least 10 minutes before handling the
lamp. This provides sufficient time for the lamp cooling fans to properly cool
the lamp. For all other precautions critical for safe removal and replacement
of the lamp. High leakage current. Earth connection essential before
connecting supply.
Section 1: Introduction
Section 5 Specifications
for rated
1-3
Advertisement
Table of Contents
