Christie J Series 2.0 kW Setup Manual page 14

Section 2: Installation and Setup
For 1900W and 2400W Models:
1. Connect the line cord of the projector to the AC receptacle at the AC inlet of the projector, then push the
wire clip over the plug to retain it, as shown.
For 3000W Model:
1. Remove the locking pin from the bracket surrounding the AC receptacle at the AC inlet of the projector by
pressing down on the button on the end of the locking pin, and then pull upwards on the pin to remove it.
2. Open the cap on the AC plug and line up the slot on the plug with the pin on the receptacle.
3. Insert the plug fully on to the receptacle. When fully inserted, the cap on the
AC plug will rest against the side of the projector.
4. Reinsert the locking pin into the bracket surrounding the AC receptacle by
pressing down on the button on the end of the locking pin and insert the pin
into the bracket, as shown.
2-4
Do not attempt operation if the AC supply and cord is not within the specified
ratings. On power down, wait 5 minutes for the fans to turn OFF before
unplugging the projector. Always switch off the projector before unplugging
the AC line cord.
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-03 Rev. 1 (02-2014)