Table of Contents
Advertisement
Auto
Initiates an automated process in which the projector optimizes critical display parameters such as size,
position, pixel tracking, etc., for the current source. These parameters are listed in the following table. An auto
setup can save time in perfecting a display and you can modify the adjustments as desired.
NOTE: You must have an unlocked channel present to use Auto Setup.
Table 3.1 Auto Setup
OPTIMIZES
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
The best auto setup will be obtained under the following conditions:
• Input levels, it is best to have an image with saturated (very bright) colors.
• Phase, high contrast edges are needed.
To determine active window size:
• Video images should have whites and blacks in the image.
• Wide range video images should have content (including white) that extends to all edges of the image.
Channel
Select a specific source setup (channel) defined and stored in projector memory. Once you enter a two-digit
channel number (or, if there is a list displayed, highlight it and press E
change and update according to the numerous setup parameters defined for that channel.
NOTES: 1) A new channel is automatically created if you adjust an image from a new source. 2) C
key behavior during a presentation depends on whether or not Display Channel List is enabled in the Menu
Preferences menu. You can choose to use a scrolling list of channels when you press C
prefer to enter the desired channel number "blind", i.e., without on-screen feedback.
Slot 1, 2, 3, 4
Press to display the next active input on the card in the slot.
Input
Displays all inputs in all slots, both active and inactive. Scroll through the list to select an input for the main
image. Press Input again to show the list and select the picture-in-picture (PIP) image.
PIP
Turns picture-in-picture ON or OFF.
Swap
Swaps the main and PIP images.
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-03 Rev. 1 (02-2014)
SETS TO DEFAULT
Contrast
Brightness
Auto Input Level (off)
Detail (if video source)
Filter
Luma Delay
Section 3: Operation
), the display will automatically
NTER
HANNEL
HANNEL
, or you may
3-5
Advertisement
Table of Contents
