Table of Contents
Advertisement
Section 1: Introduction
1.2
Safety Warnings and Guidelines
1.2.1 General Precautions
1-2
HIGH BRIGHTNESS. Never look directly into the projector lens. The extreme
high brightness can cause permanent eye damage.
Always power down the projector and disconnect all power sources before
servicing or cleaning.
FIRE HAZARD. Keep hands, clothes and all combustible material away from
the concentrated light beam of the projector. Position all cables where they
cannot contact hot surfaces or be pulled or tripped over.
In the unlikely event of a lamp explosion, particles may be blown out of the
rear air vents. Keep clear of the exhaust air path during operation. Take
appropriate precautions to shield operators and audience members from lamp
explosion particles.
High leakage current. Earth connection essential before connecting supply.
All installation and maintenance procedures must be performed by a Christie
accredited service technician.
Projector must be operated in an environment that meets operating
specifications, as listed in
The American Conference of Governmental Industrial Hygienists (ACGIH)
recommends occupational UV exposure for an 8-hour day to be less than 0.1
microwatts per square centimeters of effective UV radiation. An evaluation of
your workplace is advised to assure employees are not exposed to cumulative
radiation levels exceeding the government guidelines for your area. Be aware
that some medications are known to increase sensitivity to UV radiation.
Section 5
Specifications.
J Series 2.0, 2.4, and 3.0kW Setup Guide
020-100751-03 Rev. 1 (02-2014)
Advertisement
Table of Contents
