Loading Factory Defaults; Exiting Programming Mode - Honeywell LYNX Touch Series Installation And Setup Manual

To load the factory defaults, enter the Installer Programming Mode and advance to second page of the
System Programming and refer to following procedure
manual to view the Default Values.
If a default configuration is loaded, any data that has already been programmed into the system will be
changed according to the default configuration selected!
Select a Default Configuration
SCREEN
System Programming...
Sounder
Default Config.
Reset Master Code
Exiting Program Mode
1. Select the " " key to exit the current screen. The system returns to the previous screen.
2. Select the " " key as required until system displays a Confirmation screen.
3. Select "Yes" to allow the installer to re-enter Programming mode or "No" to prevent re-entry.
4. Select the " " key again to return to the Home Screen.
System Settings
Language
Z-Wave
5100-100-060-V0
LYNX Touch Installation and Setup Guide
Mechanics of Programming
. Refer to the Programming Default Values section of this
1. Select "Default Configuration" to display the following options:
Default Config 1
Default Config 3
Default Downloader
Note: For a list of the pre-programmed defaults refer to the
Default Values section.
2. Select the desired Default Configuration.
3. A Confirmation screen is displayed.
4. If "Yes" is selected, the System beeps three times and returns
to the Default option screen.
5. If "No" is selected, the System returns to the Default option
screen.
- 19 -

Loading Factory Defaults

ACTION
Default Config 2
Default Config 4