Program Recording (Md = Tape) - Kenwood HM-382MD Instruction Manual

44
Program recording
Desired MD tracks can be programmed in the desired sequence and recorded onto a tape.
Be sure to put the MD recorder and cassette deck in stop mode.
1
Make the preparations for recording.
MD : Insert a disc into the MD recorder.
TAPE : Perform steps 1 to 3 of the procedure
in "Recording on TAPE".
2
Program the desired sequence of MD tracks.
Perform steps1 and 2 of the procedure in "Lis-
tening in the desired sequence (Program play-
back)".
3
Put the MD recorder in pause mode before starting program playback.
(Press twice.)
4
Put the tape deck in record-pause mode.
(Press twice.)
5
Start recording.
To interrupt a recording
(Recording and playback will be
stopped.)
(MD = TAPE)
º
¤
MD
6
TAPE rec
MD
6
STOP
7
Convenient Recording Methods
÷ When the PGM/AUTO/MONO key is pressed to cancel
the edited contents, the entire editing contents will be
erased.
÷ Tracks programmed in excess of the tape recording time
will be cut off.
÷ When program playback starts, press the 4 key once
to return to the beginning of the track.
÷ Tape recording starts at the same time as the MD
program playback.
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
Note that this cassette deck cannot record onto
Metal tapes.
Note Note