Clock Adjustment - Kenwood HM-382MD Instruction Manual

Clock adjustment

As the clock is not used to show the time of the
day but is also used in timer operations, be sure
to set the clock in advance.
1
Activate the clock adjustment mode.
Press and hold for more than 2 sec.
when the power is ON.
2
Enter the figure of hour.
1 Enter the figure of hour.
multi control
To decrease
hour
2 Set it.
3
Enter the figure of minute.
1 Enter the figure of minute.
To decrease
minute
2 Set it.
menu
volume/
up
down
To increase
hour
set/demo
volume/
multi control
up
down
To increase
minute
set/demo
TIME ADJUST
÷ The time display starts to blink.
Example: Adjustment to 8:07
TIME ADJUST
÷ The time of the day is represented in 12-hour am/pm
method.
÷ Press the set/demo key. The hour is entered and the
minute display starts to blink.
Example: Adjustment to 8:07
TIME ADJUST
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the set/
demo key, the display shows "COMPLETE".
÷ After a power failure or the power cord has been un-
plugged then plugged in again, it is required to set the
time again.
÷ When the 7STOP key is pressed while the power is in
the standby mode, the time of the day will be displayed
for 5 seconds.
12:00 m a
8:00 m a
8:07 m a
59