Twin Recording Onto Md And Tape (Twin Rec) - Kenwood HM-382MD Instruction Manual

42
Twin recording onto MD and tape
All the tracks on a CD can be recorded simultaneously onto an MD and tape. (All-track twin recording)
The current track can be recorded from the beginning simultaneously onto an MD and tape. (single-
track twin recording)
Be sure to put the MD recorder and cassette deck in stop mode.
1
Make the preparations for recording.
1 MD
: Insert a disc into the MD recorder.
TAPE : Perform steps 1 to 3 of the procedure in "Recording on TAPE".
2 Insert disc in the CD player.
2
Check the current play mode of the CD player.
All-track twin recording
If it is in play mode, stop it.
3
Start recording.
1 Select "REC MODE ?" then
"TWIN REC ?".
menu
2 Start recording.
To interrupt a recording
( Recording and playback will be
stopped.)
Note that this cassette deck cannot record onto
Note Note Metal tapes.
STOP
7
volume/
multi control
up
down
set/demo
STOP
7
Convenient Recording Methods
(TWIN REC)
(Main unit only)
Single-track twin recording
Select the desired CD track and play it. &
To record other tracks using "Single-track twin re-
cording", repeat steps 2 and 3 for each track.
Turning the knob switches the display contents.
1 CD=MD<NORM> ?
2 CD=MD<HIGH> ?
3 CD=TAPE ?
4
TWIN REC ?
÷ With single-track simultaneous recording, when the set/
demo key is pressed, the "MD REC" and "TAPE REC"
indicators light and recording starts by returning to the
beginning of the current track.
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
Do not turn power off or apply shock or impact while
"WRITING" is displayed. If the power cord is un-
plugged before "WRITING" disappears, the recorded
or edited data will be lost.
º