Cisco Small Business Pro SPA9000 Administration Manual page 220

SPA9000 Field Reference
Voice tab
SPA9000 Voice System Administration Guide
Downloaded from www.Manualslib.com
Voice tab > SIP page
Auto Attendant Parameters section
AA Dial Plan 1
AA Dial Plan 2
AA script 1/2/3
Daytime AA
Day Time
DayTime AA Script
manuals search engine
Dial Plan 1 to be used in an AA script. Example: <dialplan
src=dp1/>.
Default: (10x|xxx.)
Dial Plan 2 to be used in an AA script. Example: <dialplan
src=dp2/>.
Default: (<:10>x|xxx.)
AA script. See Chapter 7, "Configuring the Auto
for the complete syntax.
Default:
<aa><form id="dir" type="menu"> <audio src="prompt1"
bargein=
"T"/> <noinput timeout="10" repeat="T"/> <nomatch
repeat="F">
<audio src="prompt3" bargein="T"/> </nomatch> <dialplan
src=
"dp1"/> <match> <default> <audio src="prompt2"/> <xfer
name=
"ext" target="$input"/> </default></match> </form></aa>
To enable the daytime Auto-Attendant, select yes. Otherwise,
select no.
Default: yes
Daytime hours for the daytime Auto-Attendant in 24-hour
format. Enter the start and end times in this format:
start=hh:mm:ss;end=hh:mm:ss (hh for hours, mm for minutes,
and ss for seconds).
For example, start=9:0:0;end=17:0:0 means that the start time
is 9 AM and the end time is 5 PM. The other hours (5 PM to 9
AM) are considered nighttime hours.
If you do not enter start and end times, the whole day (24
hours) is considered as daytime, so the nighttime Auto-
Attendant is not used, even if it is enabled.
Specifies which AA script (1, 2, or 3) is used for the AA
treatment when operating in daytime mode.
Default: 1
B
Attendant",
218