Configuring The Spa400 Network Connection - Cisco Small Business Pro SPA9000 Administration Manual

Administering the SPA400 and Voice Mail Service

Configuring the SPA400 Network Connection

Configuring the SPA400 Network Connection
STEP 1
STEP 2
STEP 3
STEP 4
SPA9000 Voice System Administration Guide
Downloaded from www.Manualslib.com
The SPA400 becomes a DHCP client of any server on the network. The
recommended setting is to use a static IP address. This configuration provides
ease of installation and prevents connectivity issues that would occur if the IP
address of the SPA400 changed.
Start Internet Explorer, and enter the IP address of the SPA400.
By default, the SPA400 is configured to obtain an IP Address via DHCP. You
NOTE
can check the obtained IP address on the router DHCP server's client list.
When the password prompt appears, enter the default user name, Admin, with no
password. Then click OK.
The user name must be entered exactly as shown: Admin. For information
NOTE
about access, refer to
Configuration Utility," on
Click Setup tab > Basic Setup.
Enter the following settings:
Network Setup section:
•
Fixed IP address: Click the radio button, and then enter a valid IP address.
To avoid addressing conflicts, enter an IP address that is outside the
NOTE
range of addresses that are automatically assigned by your DHCP
server.
•
IP Subnet Mask: Enter the subnet mask for the subnetwork that the
SPA400 is on.
•
Gateway IP Address: Enter the IP address of the router for this subnetwork.
manuals search engine
"Managing Access to the SPA400 Web-Based
page106.
5
104