Configuring A Spa400 To Interoperate With The Spa9000 - Cisco Small Business Pro SPA9000 Administration Manual

Administering the SPA400 and Voice Mail Service

Configuring a SPA400 to Interoperate with the SPA9000

STEP 7
STEP 8
Configuring a SPA400 to Interoperate with the SPA9000
SPA9000 Voice System Administration Guide
Downloaded from www.Manualslib.com
When the confirmation message appears, click OK.
When the Setup page reappears, verify that the Firmware Version number
matches the firmware version that you installed. You have successfully upgraded
the firmware.
You may need to refresh your browser to display the updated banner
NOTE
reflecting the new version number.
A SPA400 must be configured to register the SPA9000. To enable the
interoperation of the two devices, you need to enter corresponding information on
the SPA9000 Voice > Line page and on the SPA400 Setup > SPA9000 Interface
page. For voice mail service, additional entries are needed on the SPA400 Setup
> Voicemail Server page.
Be aware of the following factors:
•
You need to complete this procedure for each SPA400, whether it is used as a
PSTN gateway or as a voice mail server.
•
You need to configure a SPA9000 line interface for each SPA400. See
"Configuring a Line Interface for a SPA400 (PSTN or Voice Mail)," on page
manuals search engine
SPA400 Main Page: Firmware Version
5
60.
108