Configuring Phone Lines and Calling Routing Behavior
Managing the Line Selection for Outbound Calls
SPA9000 Voice System Administration Guide
Downloaded from
www.Manualslib.com
Configuring a Call Routing Rule
A Call Routing Rule is a special dial plan that specifies the lines that can be used to
transmit a dialed number. The same number pattern can apply to more than one
line.
SYNTAX:
( <:L
w,x,y,z>number-pattern
<:L
>
w,x,y,z
number-pattern
•
L: A signifier for "Line"
•
w, x, y, z: The number of the line interface (L1 for Line 1, L2 for Line 2, and so on)
•
port: The port number
This parameter applies only if the line interface is configured for a SPA400.
NOTE
•
number-pattern: The dialed sequence that can use the specified lines
•
Other elements:
•
Enclose the entire call routing rule in parentheses.
•
Use a comma to separate each digit sequence within a number-pattern.
•
Use a pipe character (|) to separate each call routing rule.
The Call Routing rules use the same digit sequences as the Dial Plan rules. See
NOTE
"Digit Sequences," on page
•
Allowing any line interface to be used
EXAMPLE: (<:L1,2,3,4>9xx.)
Any line interface can be used for any dialed sequence that begins with 9 and
includes at least two additional numbers. The SPA9000 chooses an available
line from the list, proceeding in the listed order. See
page
78.
manuals search engine
| <:L
w,x,y,z
|
>
<:Lw,x,y,z
number-pattern
66.
4
>
number-pattern
)
"Line Availability," on
|
79