Cisco Small Business Pro SPA9000 Administration Manual page 122

Administering the SPA400 and Voice Mail Service
Configuring a SPA400 for Voice Mail Service
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
SPA9000 Voice System Administration Guide
Downloaded from www.Manualslib.com
Scroll down to the
Dial Plan 1
Edit the AA
described below.
•
SYNTAX: (10x|xxx.|<dialcode:vmmN>)
•
EXAMPLE: (10x|xxx.|<8:vmm2>)
•
dialcode: The digit that users dial, when prompted by the Auto Attendant, to
access voice mail remotely.
The Contact List for this line must be configured for the Auto Attendant to
NOTE
answer.
•
MailboxManageNumber: The Mailbox Manage Number that was entered on the
SPA400 Voice mail Settings page. If you followed the instructions in the
procedure "Configuring a SPA400 to Interoperate with the SPA9000," on
page108, you set 800 as the Mailbox Manage Number.
•
vmmN: Replace N with the number of the SPA9000 line interface (Line 1 ... Line
4) that is configured for the SPA400 voice mail server.
Copy and paste the same string into the AA Dial Plan 2 field, for the purpose of
allowing remote access of voice mail at all times of day. For more information
about AA Dial Plans, refer to
page150.
Click Voice tab > Line
SPA400 unit.
Make sure that the
fields are set to all.
Click Submit All Changes. The SPA9000 and the phones reboot.
To verify your progress, perform the following tasks:
a. Dial into the site from an external number.
b. When the Auto Attendant prompts you for an extension, press 8.
c. When the Voice Mail Server prompts for a mailbox number, enter the mailbox
number.
d. When prompted for a password, enter the password.
manuals search engine
Auto Attendant Parameters
string to include a code for the voice mail server, as
"Configuring Dial Plans for the Auto Attendant," on
N
, where N is the number of the line interface for this
VMSP Bridge XFER Bridge Mode
,
section.
CFWD Bridge Mode
, and
5
120