Removing And Installing The Virtual Media Key; Removing The Virtual Media Key - Lenovo ThinkServer RD210 Hardware Maintenance Manual

1
CD/DVD optical drive connector
2
CD/DVD drive cable
Note: The CD/DVD cable should be routed over the top of the operation information panel cable (in the
middle) and the USB/Video cable (on the bottom) when all three cables are installed in the server.
5. Reinstall the CD/DVD drive (see "Installing a CD/DVD drive" on page 115).
6. Reinstall the fans
7. Replace the cover
8. Slide the server into the rack.
9. Reconnect the power cord and any cables that you removed.
10. Turn on the peripheral devices and the server.

Removing and installing the virtual media key

To remove and install the virtual media key, complete the steps in this section.

Removing the virtual media key

To remove the virtual media key, complete the following steps:
1. Read the safety information in Chapter 2 "Safety information" on page 3 and "Installation guidelines"
on page 67.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see "Removing and replacing the cover" on page 72).
4. Grasp the virtual media key and gently slide it up and off of the mounting tab.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
119