Good Read Led Duration - Datalogic Touch 90 pro Product Reference Manual

Reading Parameters

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 0.1 to 25.5 seconds in 100ms
increments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds. A setting of 0 means that the good read
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Scan the bar code: SELECT GOOD READ LED DURATION SETTING.
5. Scan the appropriate three digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set this feature.
Table 17. Good Read LED Duration Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad with
2
leading zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT GOOD READ LED DURATION SETTING
Scan Three Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
LED stays on until the next time the trigger is pulled.
leading zeroes to yield three digits. For example: 0 = 000, 5 = 000, 20 = 020, etc.
Mode.
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
Good Read LED
stays on until
next trigger pull
(00)
000
'0' , '0' and '0'
Appendix D, Keypad
EXAMPLES
1500ms (1.5
200ms
sec.)
002 015
'0' , '0' and '2' '0' , '1' and '5'
References
representing the
2500ms (2.5 sec.)
025
'0' , '2' and '5'
273