Ack Nak Retry Count - Datalogic Touch 90 pro Product Reference Manual

Enter/Exit Programming Mode

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to a retry
condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and
a selection of 255 specifies unlimited retries. See
more detailed programming instructions.
$CR2AR
Select ACK NAK Retry Count Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
30
DEFAULT
"ACK NAK Retry Count" on page 257
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Appendix D, Keypad
Alphanumeric characters in
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
CANCEL
003 = 3 Retries
ACK NAK Options
for
repre-
~
Touch TD1100