Global Prefix/Suffix - Datalogic Touch 90 pro Product Reference Manual

References

Global Prefix/Suffix

Up to 20 ASCII characters may be added as a prefix (in a position before the bar code data) and/
or as a suffix (in a position following the bar code data) as indicated.
Figure 4. Prefix and Suffix Positions
Example: Setting a Prefix
In this example, we'll set a prefix for all symbologies.
1. Determine which ASCII character(s) are to be added to scanned bar code data. In this
2. Go to
3. Reference the
4. If less than the expected string of 20 characters are selected, scan the ENTER/EXIT bar
5. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
6. The resulting message string would appear as follows:
264
Prefix Label ID
example, we'll add a dollar sign ('$') as a prefix.
and scan the ENTER/EXIT PROGRAMMING MODE bar code, then
page 54
scan the SET GLOBAL PREFIX bar code.
on the inside back cover of this manual to find the hex value
ASCII Chart
assigned to the desired character. The corresponding hex number for the '$' character is
24. To enter this selection code, scan the '2' and '4' bar codes from
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
NOTE
code to terminate the string.
Scanned bar code data: 12345
Resulting message string output: $12345
AIM ID Bar Code Data
00 - 20 Characters (ASCII)
Data Format
OR...
Label ID Suffix
.
Appendix D, Keypad
Touch TD1100