Enable Character - Datalogic Touch 90 pro Product Reference Manual

RS-232 Parameters

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
Determine the desired character or value.
not used (not available).
1. Determine the desired character or value.
2. Use the
3. Go to
4. Scan the bar code: SELECT ENABLE CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set this feature.
Table 10. Enable Character Setting Examples
STEP ACTION
1 Desired character/value
2 Hex equivalent from
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
7 Data Bits.
NOTE
on the inside back cover of this manual to find the hex equivalent for
ASCII Chart
the desired character/value.
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
page 33
Programming Mode.
that represent the desired character/value determined above. The second character will
cause a two-beep indication.
Mode.
'e'
ASCII Chart 0x65
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT ENABLE CHARACTER VALUE SETTING
'6' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
A setting of 0xFF indicates the Enable Character is
EXAMPLES
'}' 'E'
0x7D 0x45
'7' and 'D' '4' and '5'
References
Data Bits has been set as
,
Appendix D, Keypad
Enable Command
Not Used
0xFF
'F' AND 'F'
259