Ack Nak Timeout Value - Datalogic Touch 90 pro Product Reference Manual

ACK NAK Options

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK character from the host
following label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15
seconds) in 200ms increments. A selection of 0 disables the timeout. See
Value" on page 256
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
DEFAULT
Product Reference Guide
for more detailed programming instructions.
$CR2AT
01 ACK NAK Timeout value is 200ms
Enter/Exit Programming Mode
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Appendix D, Keypad
Alphanumeric characters in
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
CANCEL
"ACK NAK Timeout
repre-
~
29