Industrial 2 Of 5 Set Length 2 - Datalogic Touch 90 pro Product Reference Manual

Industrial 2 of 5

Industrial 2 of 5 Set Length 2

This feature specifies one of the bar code lengths for
is the maximum label length if in
Length
length does not include start/stop characters.
The length can be set from 1 to 50 characters. A setting of 00 specifies to ignore this length
(only one fixed length). See
instructions.
Select Industrial 2 of 5 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
Product Reference Guide
Mode. Length includes the bar code's check, data, and full-ASCII shift characters. The
"Set Length 2"
$CU2L2
DEFAULT
Industrial 2 of 5 Length
Variable Length Mode, or the second fixed length if in
on page 280 for more detailed programming
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
50 = Length 2 is 50 Characters
Enter/Exit Programming Mode
Control. Length 2
Appendix D, Keypad
repre-
~
CANCEL
Fixed
207