Intercharacter Delay - Datalogic Touch 90 pro Product Reference Manual

Enter/Exit Programming Mode

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
for more detailed programming instructions.
NOTE
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
42
This feature applies ONLY to the Keyboard Wedge interface.
$CR21C
DEFAULT
See "Intercharacter Delay" on page 261
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
00 = No Intercharacter Delay
Intercharacter Delay
$CR21C00 
Appendix D, Keypad
~
CANCEL
Touch TD1100