Good Read Led Duration - Datalogic Touch 90 pro Product Reference Manual

LED and Beeper Indicators

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 0.1 to 25.5 seconds in 100ms
increments. See
instructions.
Select Good Read LED Duration Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
NOTE
Product Reference Guide
"Good Read LED Duration"
$CLAGL
DEFAULT
Indicators are dimmed during sleep.
on page 273 for more detailed programming
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
020 = Good Read LED stays on
for 2 seconds.
Enter/Exit Programming Mode
Appendix D, Keypad
repre-
~
CANCEL
79