Holder/Hands-Free Stand - Datalogic Touch 90 pro Product Reference Manual

Setup
USB Connection
Connect the reader to a USB port on the terminal/PC using the correct USB cable for the
interface type you ordered.
NOTE

Holder/Hands-Free Stand

The TD1100 Holder can also be used as a hands-free stand. Insert the reader nose-first into the
holder, then pass the bar code beneath the stand. Refer to
on page 15
Figure 2. Hands-Free Stand
8
Specific cables are required for connection to different hosts. The connectors
illustrated above are examples only. Actual connectors may vary from those illus-
trated, but the steps to connect the reader remain the same.
for information about programming the reader for use with the stand.
USB Interface
"Configuration Using Bar Codes" starting
Holder/Hands-Free Stand
Touch TD1100